Installation of lighting system KRAFT LED

Recommendations for self-installation of lamps KRAFT Led

We produce three types of KRAFT LED luminaires - T-LED, G-LED and K-Led. T-LED is used for standard suspended ceilings with a supporting structure made of profiles T-15 or T-24. G-LED is used for grilyato, slats and other types of suspended ceilings. K-LED are universal fixtures for all types of ceilings (not only suspended).

 G-LED 24 mm wide on the rail  G-LED 15 mm wide on griglyato  T-LED on profile Т-24   T-LED on profile Т-15
Installation of the exhibition stand of products KRAFT with LED profile KRAFT LED

K-Led luminaires are full-fledged luminaires based on a KRAFT Cubic rail.

1. Calculation of lighting

In the program "Dialuxe" we determine the optimal number and location of lamps.

If you are unable to do the calculation of the lighting in the program, you should proceed from the approximate values: one set of KRAFT LED lamps is designed for lighting 10-12 square meters. m rooms with a height of 3.5 m area up to 20 square meters. m and 12-14 square meters. m room area of over 20 square meters. m. In this case, evenly distribute the lamps throughout the room.

2. Lighting scheme

In the program "Dialuxe" or on the plan of the room we indicate the location of the fixtures. This scheme will be used during the installation.

3. Installation of LED profiles KRAFT LED

3.1. Installation T-LED

LED profile T-LED is mounted in the desired location of the suspended ceiling design instead of the standard T-profile 600 or 1200 mm.

Wires for connection have already been put into the ceiling area. It remains only to connect the kit to the driver.

3.2. Installation G-LED

To install the G-LED LED profile, first mark its position on the structure. If necessary, drill holes for the output of wires. Then remove the red protective strip from the back side of the profile, take the wires out into the ceiling area and glue the profile to the surface of the grillato or slats.

3.3. Installation K-Led

The K-Led lamp driver is hidden directly inside the rail. Thanks to the new type of mounting, such lamps can be mounted either directly to the ceiling or on any hangers, including their own wires.

4. Driver connection

After the LED profiles are installed, we connect them to the power supply according to the wiring diagram. Drivers can be placed at any distance from the luminaires and carried to a convenient or specially designed place.